Operation Manual

4
Graphical Interface
Orbit's has three types of hardware controls whose MIDI messages you can edit. This section
explains how to adjust the MIDI message sent by each type of hardware control.
Important: Remember that there are four banks of controls. When editing your mappings,
make sure you are on the bank you want. Click the desired Pad Bank button in the graphical
interface to select the bank. The bank number will display in the Edit Mappings panel, and the
values on the graphical interface will reflect those of the current bank only.
Tip: If you want to set a MIDI note number, MIDI CC number, or MIDI channel number to all
pads, all virtual knobs, or both accelerometers, see the Apply section below. This feature lets
you "copy" a single value or set ascending values across all similar controls.