User Manual

5
Features
Rear Panel
1. Power Input: Connect the included power
cable to this input and connect the other end
of the cable to a power source. Make sure the
loudspeaker's Power Switch is set to "off"
when plugging and unplugging the cable.
2. Fuse: If the unit's fuse is broken, lift this tab
to replace the fuse. Replace it with a fuse with
an appropriate rating (printed under the unit's
power cable input). Using a fuse with an
incorrect rating can damage the unit and/or
fuse.
3. Power Switch: Turns the loudspeaker on/off.
Make sure the Master Volume knob is set to
"zero" before turning it on.
4. Power LED: Illuminates when the
loudspeaker is on.
5. Input: Use a standard 1/4" (6.35 mm) TRS or
XLR cable (not included) to connect your
sound source to Channel 1. Use a standard
1/8" (3.5 mm) TRS or RCA cable (not
included) to connect a sound source to
Channel 2. If you use a microphone that
requires +48V of phantom power, you must
connect it to an external phantom power
supply. Lightwave does not supply any
phantom power.
6. Input Volume: Turn this knob to adjust the
input volume of the channel.
7. Link Output: Use a standard XLR cable (not
included) to connect this output to the input
of another loudspeaker. The signal sent from
this output is a summed mono signal of all
three Inputs, post-Input Volume.
MOOD
METER
MIX
PULSE
PARTY
1
2
3
4
5
5
5
6
6
7
8
9
11
10