Operation Manual

 Calibrate

This function is used to calibrate the pitch sliders. Your DDS

has been pre-calibrated at the factory, but the characteristics

of the sliders may change slightly over time. If the top, center

and bottom positions no longer align with the expected pitch

range you should run this calibration routine.

Select Calibrate, then when prompted:

1. Move both sliders to the fully upward position (to the -

% symbol)

2. Select Next

3. Move both sliders to the center position

4. Select Next

5. Move both sliders to the fully downward position (to the +% symbol)

6. Select Next

Calibration is now complete. Press the Utility button to exit.

Note: If you mix up the calibration procedure by swapping over the minus and plus ends of the

scale, the pitch slider will have no effect! Simply re-run the calibration.

 Updates

The Updates page shows the current software version of

the DDS. Please check http://www.numark.com

regularly

for available software upgrades. If the version of the

software upgrade on the website is higher than the version

of the current software on your DDS, please follow the

upgrade procedure outlined in the next section of this

manual.