Operation Manual

32
UTILITY
The Utility button gives access to System information and settings.
The main utility work area displays the unit serial number.
This information is useful if you need to contact Customer
Care or check for firmware updates at the Numark web site.
Tip: It is strongly advised that you periodically compare
your firmware version with that available at the
Numark web site, and install any more recent version
that may be available. New software will be posted
regularly to add features and fix problems. See “DDS
Software Upgrades” section for details.
Further utility screens are accessed from the menu as follows.
 Display
From here the display brightness can be adjusted.
Also, a scale of shades from black to white is shown on
screen as an aid to setting the display contrast. Adjust the
contrast by rotating the Display Contrast knob located to
the left of the display until the left most segment of the scale
is black, the right most is white, and three shades can be
identified in between.
 Restore
This operation will reset the unit to default settings. Select
Restore to proceed, or press Utilty or another function
button to cancel. Just to be really sure, you will be asked one
more time if this is something you want to do. Select Yes or
No as appropriate.
The default settings are:
Pitch Range 12%
Track Loading - Manual
Time Display - Elapsed
Fader Start - Off
Display Brightness – Center Position
Note that the calibration (see below) will not be reset by this operation.