User Manual

Features

Rear Panel

1. Power Input: Use a power cable (included) to connect this to a power outlet.

2. Power Switch: Use this switch to power N-Wave 580L on or off. Turn on N-Wave 580L

after all input devices have been connected.

3. Speaker Link (Right): This is the audio connection to the left speaker. Use the included

1/4” (6.35mm) TRS cable to connect the right speaker to the left speaker.

4. Speaker Link (Left): This is the audio connection from right speaker. Use the included

1/4” (6.35mm) TRS cable to connect the left speaker to the right speaker.

5. Output to Left LED: This is the LED connection to the left speaker. Use the included 4-pin

LED connection cable to connect the right speaker to the left speaker.

6. Input from Right LED: This is the LED connection from right speaker. Use the included 4-

pin LED connection cable to connect the left speaker to the right speaker.

7. LED Mode: Press this button to cycle through the available light modes:

• Off: The lights will be off.

• Pulsate Mode: The audio signal will cause the lights to pulse. When there is no

audio signal, the lights will enter Slow Cycle Mode.

• Slow Cycle Mode: The lights will illuminate and change colors regardless of the

music playing.

8. Inputs (RCA): Connect your audio interface, mixer, etc. to these inputs, using a standard

RCA cable.

9. Input (1/4” / 6.35 mm TRS): Connect your audio interface, mixer, etc. to this input, using

standard 1/4” (6.35 mm) TRS cables.

10. Bass Boost: This two-position switch allows you to boost the speakers’ bass frequencies.

11. Vol (front panel, not pictured): Use this knob to adjust the speaker’s volume.