User's Manual

 C button: Continuous stimulation
Press the «C» button to send a warning to your dog using stimulations transmitted by two contact points
located on the receiver collar, the duration will be as long as you press the button but limited to 8
seconds maximum.
Nota: Beeps can be associated to the stimulations by pressing
first the “C” button and then the button.
 « + » and « - » : control buttons
Use the “+”/”-“ buttons for rapid
adjustment of the stimulations level of the receiver collar.
9 levels are available.
Level 1:
very weak stimulation – Level 9: strong stimulation
● Checking/replacing battery of remote control
The performance (radio range) of the remote control may deteriorate as batteries become
weak. Be prepared to replace the battery.
To check the condition of the battery, turn on the remote control and look at the battery level indicator on
the LCD screen. The symbols which appear indicate the following:
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your CANICOM 200 functions in safety mode and the system locks up. The
battery must be replaced.
Remove the old battery and replace it with a new one as follows:
▪ On the back of the remote control, unscrew the screw and remove the battery cover.
▪ Remove the old battery, using the special tab.
▪ Insert the new battery (3-V lithium CR 2430)
making sure the polarity “+” noted on the
battery is visible (ref. Diagram 6). The tab is under the battery.
▪ Put the lid back in place, making sure the tab is in correct position (inside the battery housing) to
maintain water tightness.
▪ Put the top back, using the screw.
▪ Check the remote control operates correctly.
Diagram 6
« + » of the
battery must
be visible
● Checking/Replacing battery of receiver collar
To check the condition of the receiver collar battery, observe the indicator light located on the front of the
receiver collar:
9 Battery fully charged: flashes slow green.
9 Weak battery: flashes quickly red. Replace the old battery with a new one (3-V Lithium CR2) (See
§ First use from new – Fitting the battery in the receiver collar).
Check the receiver collar operates correctly.
● Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog’s skin, enabling the device to operate correctly.
CANICOM 200 – User’s guide – indice C
7/12