User's Manual
Table Of Contents
- Index Page
- ▪ Contents of the product 4
- ▪ Checking/replacing battery of remote control 7
- ▪ Checking/replacing battery of receiver collar 7
- ▪ Maintenance 9
- ▪ Troubleshooting 9
- ▪ Technical specifications 10
- ▪ Receiver collar battery life 11
- ▪ Warranty 11
- ▪ Warranty conditions 11
- ▪ Spare parts 11
- ▪ Collection and recycling of your device at the end of its life 12
- ● Contents of the product
- Diagram 4
- ● Checking/replacing battery of remote control
- The performance (radio range) of the remote control may deteriorate as batteries become weak. Be prepared to replace the battery.
- ● Checking/Replacing battery of receiver collar
- ● Maintenance
- ● Troubleshooting
- ● Technical information
- ● Receiver collar battery life
- ● Warranty
- ● Warranty conditions
- ● Spare parts
- ● Collection and recycling of your device at the end of its life
● Contents of the product
Inside the packaging you will find:
▪ 1 receiver collar CANICOM fitted with short contact points
▪ 1 lithium 3 Volts CR2 battery for the collar
▪ 1 remote control CANICOM 200 fitted with 1 lithium 3 Volts CR2430 battery
▪ 1 neon test lamp
▪ 1 pair of long contact points
▪ 1 carry strap
▪ 1 DVD
▪ This user’s guide
● Description of the product
On/Off
switch
Continuous stimulations
limited to 8 seconds
Flash stimulations
lower than 1 second
Red mark:
Area where
the On/Off
switch magnet
is located
LCD screen
RECEIVER COLLAR
Diagram 2
REMOTE CONTROL
Diagram 1
2 contact points
(short or long)
Adjustment of the level
of the stimulations
On/Off indicator
+
indicator of
radio reception
+
battery level
indicator
Battery level indicator
THT level indicator
from 1 to 9
Indicator of radio
transmission
LCD SCREEN
Diagram 3
● First use from new
Fitting the battery in the receiver collar
▪ Unscrew the 4 screws of the top of CANICOM using a screwdriver.
▪ Insert the battery (3V Lithium CR2)
paying attention to follow polarity indicated on the
battery housing (ref. Diagram4). The tab is under the battery.
▪ A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
CANICOM 200 – User’s guide – indice C
4/12