User's Manual
Table Of Contents
Coding of the remote control and receiver collar(s)
Each remote control has its individual radio operator code.
The coding of the remote control with the receiver collar(s) enables to couple your remote control with the
receiver collar(s) provided.
IMPORTANT: before beginning the coding (first use of the receiver or re-coding), make sure no
other person is using his CANICOM 400 or other products from the NUM'AXES range close by.
Your receiver could accidentally record the code of his remote control. If that occurs, re-code
the remote control with the receiver collar.
For CANICOM 400:
Collar A = collar with black strap – Collar B = collar with yellow strap
CODING PROCEDURE FOR THE FIRST USE
Warning: if you have several collars, you have to code them one at a time.
1. Activate the remote control: Press for 1 second the On/Off red button (
) located on the side of
the remote control.
2. Select the collar you want to code on the remote control: Press the A or B key in order to
select the collar (the letter A or B will appear on the LCD screen).
3.
Activate the receiver collar: Approach the area where the On/Off switch magnet is located in the
remote control until coming in contact on red mark located on the receiver collar for 1 second.
4. Move the remote control away from the receiver collar.
5. Press the button
of the remote control. A beep sound is emitted, the receiver collar is then
synchronized with your remote control.
If you have several collars to code, renew the same procedure for each one.
RE-CODING PROCEDURE (for all the codings except the first one)
Warning: if you have several collars, you have to re-code them one at a time.
1. Activate the remote control: Press for 1 second the On/Off red button (
) located on the side of
the remote control.
2. Select the collar you want to re-code on the remote control:
Press the A or B key in order to select the collar (the letter A or B will appear on the LCD screen).
If you have several collars to re-code, renew the same procedure for each one.
Reprogram a receiver collar
The CANICOM receiver collar can be re-coded indefinitely,
either with the same remote control, or with a
new remote control from the CANICOM range.
Ref. Re-coding procedure
● How to use the remote control
The CANICOM 400 remote control is designed to operate with 1 or 2 receiver collar(s). For optimal range
performance, hold the remote control in front of you with your arm extended, at least 10 inches away
from your body. Do not cover the top of the remote control unit or antenna with any part of your hand
Before sending any training instruction (beeper or stimulations), you have to select the dog
you want to send a message to:
- dog A (black collar) or dog B (yellow collar) for CANICOM 400
To select the dog you want to train on the remote control:
Press the A or B key in order to select the collar (the letter A or B will appear on the LCD screen).
CANICOM 400 – user-s guide – indice A 6/12