Installation Guide

Mounting Bar Edge Rafters (2) Support Arms Small Screws

Top Trim Canopy Rafter Interlock Clips Large Screws

Front Gutter Slat Sections Deluxe Casting

Actual Size End Views of Door Canopy parts for easy reference and assembly:

mounting bar (a)

top trim (b)

support arms

(2) 36” - 84”

(3) 85” and over

slat sections

(4-10) based on

model ordered

deluxe casting

(1 per arm)

front gutter (c)

edge rafter (2) (d)

canopy rafter (e)

Phillips, Regular & 1/4” Hex Head

Screwdrivers or Bits Channel Lock Pliers Power Drill Level Tape Measure

Series 1100 Parts Check List:

Series 1100 with Support Arms

Required Tools:

slat section seams

Mounting Bar (A) Top Trim (B) Front Gutter (C) Edge Rafter (D) Canopy Rafter (E)

Series 1100

Aluminum Door Canopy

with Support Arms

It is our recommendation that you read instructions carefully

prior to assembly and installation.

QUANTITIES & SIZE OF PARTS MAY VARY BY AWNING SIZE AND MODEL SERIES

www.nuimageawnings.com

PAGE 1
www.nuimageawnings.com Series 1100 Aluminum Door Canopy with Support Arms It is our recommendation that you read instructions carefully prior to assembly and installation.
PAGE 2
Assembly Instructions Series 1100 Aluminum Door Canopy with Support Arms It is important that the Canopy Slats are assembled properly so that rain water will not leak through the seams where the slats join. 1 The canopy is assembled upside down. Note that the Slat Sections are packaged upside down (FIG. 1A). Assemble on a flat surface. Slats have a slight curve to them. Keep them this way for assembly. FIG. 1A l! CAUTION: Canopy parts may have sharp edges. Use care in assembly.
PAGE 3
8 Align Canopy Rafter with pre-punched holes in the center of the Top Trim first and secure with small screws. Then, repeat with the other end of the Canopy Rafter in the center on the Front Gutter and secure with small screws. Top Trim Canopy Rafter NOTE: Door canopies wider than 60” need more than one canopy rafter. Pre-punched holes will guide installation of multiple canopy rafters. FIG.
PAGE 4
Thank you for ordering the Series 1100 Aluminum Door Canopy NuImage Awnings® has a full line of aluminum awnings to complement your selection. Contact your local home improvement retailer, or visit www.nuimageawnings.com today to learn more about these other quality products made in the USA.