Instructions / Assembly

8
Now install Canopy Rafter.
Align Canopy Rafter with pre-punched holes in the center of the Top Trim
first and secure with small screws, then do the same at the other end of
the Canopy Rafter in the center on the Front Gutter and secure with small
screws.
Note: Door canopies wider than 60” need more than one canopy rafter.
Pre-punched holes will guide installation of multiple canopy rafters
9
Next install Interlock Clips.
Connect Canopy Slat Section to the canopy rafter using interlock clips
at each joint where the slats interlock. Installing clips is a two-step
process: first insert the curved part of clip into slat joint, then slide clip
onto Canopy Rafter. Interlock clips are installed on the flat section of the
awning only, not at the curve. If stubborn, make sure they are straight
and parallel with the slat joint.
1
Install Mounting Bar and secure with large screws above the door.
Models with standard Support Arms require a minimum of 3 inches
above door.
Be sure the Mounting Bar is level and centered over the opening. Screws
must be in studs or heavy sheathing. (Drill alternate holes in bar if
necessary)
Caulk the top of the Mounting Bar against the house.
Note: Models with Sidewings require 13 inches for standard sidewings
and 6 inches for special ordered Low Mount Sidewings.
2
Attach Support Arms on Front Gutter with small screws. Install
Adjustable Hinge Brackets to opposite ends of support arms and hand
tighten set screws. The Adjustable Hinge Brackets will need re-adjusting
and leveling when fastening to the house.
Note: For models with Sidewings, please see instructions on back.
3
Align the front of the Canopy above the Mounting Bar and insert the
Top Trim into the Mounting Bar (allow Support Arms to rest on the
house). Align holes and secure Top Trim to Mounting Bar with small
screws from bottom side, as shown.
Canopy
Rafter
Interlock
Clip
Caulk
Mounting
Bar
3 inch
minimum
Adjustable
Hinge Bracket
Arm
Front
Gutter
Mounting
Bar
Top Trim
Inserted
4
Adjust Support Arms for desired pitch. Be sure door opens completely
before attaching.
Align Adjustable Hinge Brackets, level and secure to wall with
large screws.
Tighten set screws on brackets.
Installation is now complete.
Adjustable
Hinge
Bracket
Top Trim
Installation Instructions with Support Arms
(Awnings ordered with Support Arms do not include Sidewings, however Sidewings can be ordered separately)
!
!
Apply a bead of caulking in the trough of the mounting bar
prior to installation of the awning’s top trim placement onto
the mounting bar.
Small Screws
WARNING: Canopies over 84” wide will include additional support arms. They must be installed so that no more than
84” of width is unsupported. Arms should be evenly spaced for maximum support.