Instructions / Assembly

The 2700 Series Door Canopy is now ready for installation.
1
Install Mounting Bar with large screws 13” above the door.
Be sure the bar is level and centered over the door opening. Screws
must be in studs or heavy sheathing.
(Drill alternate holes in bar if necessary)
Please refer to Step 1 - Detail to place the Mounting Bar correctly
on the wall.
Installation Instructions
2
Flip the Canopy over to its installed position (as shown above)
then lift the Canopy up and angle the Top Trim insert into the
Mounting Bar and let it down slowly. It will rest here locked in
place while you secure it. Please refer to Step 2 - Detail for cross
section diagram.
Secure the Mounting Bar & the Top Trim together with small
screws in pre-punched holes from underneath.
3
Attach the (2) two loose Camel Back Wall
Brackets, temporarily, to the other end of the
Support Arms using a machine screws.
Before securing Support Arms with Camel Back
Wall Brackets to your house please refer to the
mounting chart here for model number and
correct mounting points for your Awning.
Note: Mounting dimension ‘A’ is measured from
the top of the Mounting Bar to the center of the
Camel Back Wall Bracket -shown at left.
Now attach mounting brackets to the house
using large screws making sure the Camel Back
Wall Brackets are secured in solid sheathing at
the proper points from the reference chart.
4
After Camel Back Wall Brackets have been secured to the
house, remove the machine screws and re-insert them through
grommeted tabs on your awning to secure the Canopy sides and
screw them back into the camel back wall brackets.
Installation is now complete.
Caulk
Mounting
Bar
13 inch
clearance
Mounting
Bar
Small Screws
Detail: Mounting Bar
& Top Trim - Cross
Section Connection
!
!
Apply a bead of caulking in the trough of the mounting bar
prior to the awning’s top trim placement into the mounting bar.
Door Canopy Mounting Chart
Model Number
4 5 6 7 8
Mounting Point
7 1/2” 9” 10 1/2” 12” 13 1/2”
Camel Back Wall
Brackets
Mounting Bar
(Front) - Awning Frame Views - (Side)
Mount Camel Back
Wall Brackets
plumb & in line with
Mounting Bar
Mounting Bar
Detail: Position the
Mounting Bar against
the wall in this way
Wall
Mounting Bar
Caulk the top of the mounting bar against the house.