Instructions / Assembly

Assembly Instructions The 2700 Fabric Door Canopy
1
The 2700 series Fabric Door Canopy comes packaged in two
separate plastic bags one with the hardware & instructions and in
the other the Canopy with three frame pieces, a Mounting Bar, Top
Trim & Front Trim - (for your convenience the Front Trim & Top Trim
frame parts are already attached to the Canopy).
2
3
Attach one Edge Canopy Rafter to the Front Trim using small
screws in pre-punched holes - the Front Trim is behind the
Valance on the inside of the Canopy and is pre-attached.
Note: Be sure to position the Edge Canopy Rafters so that the
ends with the attached Camel Back Wall Bracket / Support Arm is
toward the outside and at the front of the Canopy (Front Trim).
4
Attach the other end of the Edge Canopy Rafter to the Top Trim
on both sides using two small screws in pre-punched holes.
Repeat steps 3,4 & 5 for the second Support Arm and secure the
other Edge Canopy Rafter on the other side of the Canopy.
5
Position the Center Rafter in the center of the Canopy and align
with pre-punched holes at the front trim & the top trim. Then,
fasten the Center Rafter to the Front Trim 1st and then the Top
Trim with two small screws at each end. (as shown in Step 6
details)
Picture Inserts: The Fabric Canopy is turned vertically to show
placement of Center Rafter with attachment details to the Front
Trim & Top Trim.
6
Begin by attaching one end of one of the Support Arms to the
Edge Canopy Rafter by inserting it into the Camel Back Wall
Bracket that is already mounted on the Edge Canopy Rafter using
a machine screw.
Note: Insert the machine screws through the Camel Back Wall
Bracket and the Support Arms from the outside in toward the
Canopy.
Support Arm
Camel Back
Wall Bracket
Edge Canopy
Rafter
Center
Rafter to
Front Trim
Center
Rafter to
Top Trim
Center
Rafter
Hardware Pack
Canopy Pack
Support Arm
with Camel Back
Wall Bracket
Front Trim
Edge Canopy
Rafter
Front Trim
Edge Canopy
Rafter
The 2700 Door Canopy will come rolled with the top or outside
rolled to the inside. Unroll the Canopy, {The Mounting Bar,
rolled inside the Canopy will be used in Step 1 of the installation
instructions, set it aside for now}. Open the sides, then ip the
whole Canopy over. The Canopy will be assembled from this
position, upside (or topside) down and inside or underside UP.
Notice, as mentioned above, the top trim and front trim frame
pieces are already attached.
The Front Trim
& the Top
Trim are pre-
attached with
the Mounting
Bar rolled in
loose
Mounting Bar