QUICK START GUIDE IN THE BOX: USB CHARGE CABLE CHARGE CASE EAR TIP TRAY CARRY BAG IQBUDS2
CHARGING YOUR IQBUDS AND CASE Your case carries and charges your IQbuds. Your case provides you with the convenience of charging your IQbuds when you are out and about. You can charge your case via the USB cable connected to a USB power source (Wall charger, computer, etc.) The case has lights that indicate different states, please see below: FRONT LIGHTS (IQBUDS CHARGE) SIDE LIGHT (CASE CHARGE) *Please note that the lights will turn on when the case is opened or closed.
FITTING YOUR IQBUDS INSERTING IQBUDS Check the IQbuds for left and right markings to make sure you put the correct bud in the correct ear. Make sure the tip is at the bottom before inserting. FIT LIKE AN EARPLUG For high quality bass and noise reduction IQbuds need to form an airtight seal. Push the buds into your ears as you would an earplug. EXPERIMENT WITH TIPS Pick the largest size ear tip that fits in your ear comfortably and forms the best seal.
APP SETUP + PAIRING Download the IQbuds app to begin the set up process. All set up instructions will be in the app to guide you. TAP TOUCH These highlighted green surfaces are the tap sensors. You can control different features with tap gestures. PAIRING To activate pairing mode, hold both tap sensors for about 5 seconds, Wait until you hear “Pairing”. This will allow your phone to discover your IQbuds in bluetooth settings and in the app.
BLUETOOTH iOS (Apple) After the pairing screen you will be presented with different options based on what software version your phone is running. iPhones with iOS 13 and above will allow you to pair in the app. You will be shown a pop up message asking you to pair, like this: Tap “Pair” and you will be able to proceed through the app to complete the process.
Android After the pairing screen you will be presented with a pop up message asking you to connect, like this: *IQbuds2MAX_XXX All IQbuds have a unique three letter/number code Tap “Connect” and you will be able to proceed through the app to complete the process. If you have not activated pairing properly you may be taken back to the pairing screen, in which case try the pairing action again and wait until you hear “Pairing”.
TAP TOUCH CONTROLS Please note the below are default settings. You can customize them in Tap Touch in the app. This allows you to pick and choose different functions to assign to different tap gestures so you can personalize the way you control your IQbuds.
