Instruction Manual

3
SETUP INSTRUCTIONS
1. Unpack and Power Up
- Package contains: Sensor, Display,
Container, USB charger, and USB cable.
- Connect the power supply to an outlet
and to the display and turn on the display.
- Follow setup instructions on the display.
2. Attach sensor to water meter
- Locate your water meter and make sure
it’s sides are accessible.
- Attach the sensor around the water meter
(as a belt). Do NOT block the water meter
reading dial.
- Rest the battery enclosure on the ground.
3. Deploy sensor antenna
- Unfold sensor antenna.
- Use the telescoping mast to move the
antenna up as close as possible to ground
level.
- Rotate antenna so that it is oriented
parallel to the front of the house.
4. Setup and calibration
- Use the display to setup the system, adjust date/time,
connect to Wi-Fi, and to register.
- Follow instructions on the display to initialize and calibrate
the sensor. Remove all foam from container prior to
calibration.
- To power up the sensor tighten the battery enclosure lid.
LED will light up. After initialization LED stays off.
- Pleco is ready to use.
5. Install the smartphone app
- The Pleco app is available at no extra cost at the Apple Store and
Google Play.