8.5
Table Of Contents
- Table of Contents
- Preface
- Chapter 1 – Introduction
- Chapter 2 – Installation
- Chapter 3 – TextBridge Pro Tools
- Chapter 4 – Using TextBridge Pro
- Chapter 5 – Tutorials
- Chapter 6 – Tips and Techniques
- Appendix A – Troubleshooting and Error Correction
- Appendix B – Sample Documents
- Appendix C – AppleScript Interface
- Glossary of Terms
- Index
A–28 TextBridge Professional Edition User's Guide
Quality of scanned image is poor
• Check settings; 300 dpi resolution usually works best with
most documents. For 8 points or smaller, 400 dpi is
recommended.
TextBridge Pro hangs or crashes when attempting to scan
• Refer to Basic Troubleshooting Steps for crashes in this
chapter.
Doesn’t scan, but TextBridge Pro says it did
Ofoto is installed:
• Restart Mac and Scanner.
• Start Ofoto.
• Make the Finder the active application.
• Start TextBridge Pro.
• Select Source.
• Quit Ofoto.
• Run TextBridge Pro normally.
Other Problems after Clicking Go
• Check for extension conflict (see Trouble Shooting—Crashes).