8.5
Table Of Contents
- Table of Contents
- Preface
- Chapter 1 – Introduction
- Chapter 2 – Installation
- Chapter 3 – TextBridge Pro Tools
- Chapter 4 – Using TextBridge Pro
- Chapter 5 – Tutorials
- Chapter 6 – Tips and Techniques
- Appendix A – Troubleshooting and Error Correction
- Appendix B – Sample Documents
- Appendix C – AppleScript Interface
- Glossary of Terms
- Index
Troubleshooting and Error Messages A–27
Scan problems after Clicking GO
See error messages 1076, 1077, 1081, 1083, 1106, 1107, 1108, and
1120 for explanations and possible solutions.
Scanning or scanner test software supplied by the scanner
manufacturer.
• Try scanning using the software supplied by the scanner
manufacturer.
• If you can scan using that software, the problem probably is
not with the SCSI cabling or hardware.
Scanner uses sheet feeder even when check box is not
checked
• Power down scanner and disconnect ADF cable.
Manual Brightness setting gives incorrect result
• Try a different manual setting (for example, one less or one
more).
• Set the brightness to normal image.
• With Preview on invert the image.
Image inverted in Preview
• Try Manual Brightness (the steps outlined in the previous
item).
• Set the Control Panel to 256 colors.
Brightness setting changes do not seem to affect scanned
image
• Look carefully, some scanners do not have a wide brightness
range.