7.0

System Requirements
18 - Installation and Setup
System Requirements
To install and run OmniPage Pro, you need the following setup:
 Standard Macintosh (68020 or greater) or Power Macintosh
 System 7.0 or later (System 7.5 or later required for Drag and
Drop feature)
 For a 680
x
0 Macintosh, at least 5MB RAM of free memory
 For a Power Macintosh, at least 5MB RAM free memory if virtual
memory is on (8MB if virtual memory is off)
 640x400 resolution display or better
 At least 12MB available hard disk space for OmniPage Pro files
and temporary storage while OmniPage Pro is running
 A supported scanner if you plan to scan documents
See the supported scanner list in the
Scanner Setup Notes
. Your
scanner and the driver supplied by its manufacturer, if any, must
be installed on your system according to the manufacturer's
instructions.
Installing the Software
Before you install OmniPage Pro:
 Make sure your scanner is working on your system by using the
scanning software supplied by the manufacturer.
 Remove the
Dragging Enabler
file from your
Extensions
folder if
you use System 7.0 or 7.1 and have Drag and Drop installed. This
file is not compatible with Apple Guide 2.0. OmniPage Pro
installs Apple Guide files that contain all the necessary
functionality.
 Turn off any virus-protection software. This is often a Control
Panel device. Refer to your virus-protection software manual for
more information.
To make installation go faster and to avoid software conflicts, it is
recommended that you turn off system extensions before installing
OmniPage Pro. Restart your Macintosh while holding down the Shift
key to temporarily turn off all system extensions. After OmniPage Pro
installation, you can restart your Macintosh normally.