16.0

12 Chapter 1
or click the Setup button in the Scanner panel of the
Options dialog box.
or choose Scan in the Get Page drop-down list in the
OmniPage Toolbox and click the Get Page button.
• The Scanner Setup Wizard starts. If you have a web
connection, the first panel invites you to update the
scanner database supplied with the wizard. Choose Yes or
No and click on Next.
• Choose ‘Select and test scanner or digital camera’, then
click Next. If you have a single installed scanner, it
appears, along with any scanners previously set up with
OmniPage. If the required scanner is not listed, click Add
Scanner... .
• You see a list of all detected scanner drivers in the
checkmarked categories. This can include network
devices. Select one and click OK. To install a second
device, you must run the Scanner Wizard again.
• The wizard reports whether the chosen scanner model
already has settings in the scanner database. If it does, you
do not need to test it. If it does not, you should test it.
Click on Next.
• If you chose not to test, click Finish. If you chose testing,
click Next to have the scanner connection tested. If the
connection is in order, you see a menu of further tests.
Choose which testing steps you want to run. The Basic
test scan is recommended.
• By default OmniPage uses its own scanning interface,
located in the Scanner panel of the Options dialog box. If
you want to use your scanner’s own interface instead,
choose Advanced settings... and select this. Click Hint
editor... and choose Edit hints... only if you are experienced
in configuring scanners or have been advised by Technical
Support to do so.