14.0

Chapter 6
Workflow Assistant 99
If you selected a workflow or job as source, you proceed by modifying its
steps and settings. See the next section. If you save the workflow to a new
name, the changed settings apply to the new workflow only and are not
written back to the workflow or job used as the source. Similarly, when
you make a new workflow with Fresh Start as source, its panels present
settings as they were last set in OmniPage Pro. Any changed settings
enter the new workflow, but do not affect the settings in the program.
We now describe the creation of a workflow from a fresh start. Click
Next to proceed to the panel where the input is defined:
Workflow
diagram:
The series of steps
in your chosen
workflow appear
here.
When you are
satisfied with
your choice,
click Next.
The starting point for
your workflow will
be an existing one.
This lists your
workflows. Select
one to see its steps
in the panel on the
right.
Choose one input step:
Load Image Files: Choose this and click Next to
define file names or request run-time prompting
and input settings.
Scan Images: Choose this and click Next to
define scanner settings for the workflow.
Open OmniPage Document: Choose this to
open a partially processed OPD file that your new
workflow should handle. Click Next to name the
file.
Use Current Document: Choose this to use a
document in OmniPage Pro as input. Be sure
OmniPage Pro is running with a suitable document
when you start a workflow with this step.
Other input: Depending on your OmniPage Pro
version and computing environment, other input
sources may be available.