11.0
Table Of Contents
- Welcome
- 1 Installation and setup
- 2 Introduction
- 3 Tutorial: Processing documents
- Quick Start Guide
- Processing documents using the OCR Wizard
- Processing documents automatically
- Processing documents manually
- Processing a document automatically and finishing it manually
- Processing from other applications
- Processing documents with Schedule OCR
- Defining the source of page images
- Describing the layout of the document
- Manual zoning
- Table grids in the image
- Using zone templates
- 4 Proofing and editing
- 5 Saving and exporting
- 6 Technical information
12 INSTALLATION AND SETUP
S
YSTEM
REQUIREMENTS
You need the following minimum system requirements to install and run
OmniPage Pro 11:
◆
A computer with a Pentium or higher processor
◆
Microsoft Windows 95, Windows 98, Windows ME, Windows
2000, or Windows NT 4.0
◆
32MB of memory (RAM), 64MB recommended
◆
75MB of free hard disk space for the application files plus 10MB
working space during installation
◆
9MB for Microsoft Installer (MSI) if not present and 44MB for
Internet Explorer if not present. (These are present as part of the
operating system in Windows 98, Windows ME and Windows
2000.)
◆
SVGA monitor with 256 colors and 800 x 600 pixel resolution
◆
Windows-compatible pointing device
◆
CD-ROM drive for installation
◆
A compatible scanner if you plan to scan documents. Please see
the Scanner Guide at ScanSoft’s web site (www.scansoft.com) for
a list of supported scanners.
Note
Performance and speed will be enhanced if your computer’s
processor, memory, and available disk space exceed minimum
requirements.