15.6
Table Of Contents
- Dragon_NMCInstallGuideCover_20160929_v4_Cloud
- About this guide
- Chapter 1: Introduction
- Chapter 2: Preparing for your installation
- Chapter 3: Post-installation tasks
- Chapter 4: Preparing for your Active Directory single sign-on configuration
- Chapter 5: Installing the Local Authenticator
- Chapter 6: Preparing for your Central Authentication single sign-on configuration
- Central authentication overview
- Supported identity providers
- Supported federation relationship types
- Checklist—Planning your Central Authentication single sign-on setup
- Obtaining required information
- Configuring Central Authentication
- Installing the Active Directory/LDAP connector
- Viewing Central Authentication audit events
Nuance Management Center Server Installation and Configuration Guide
Editing the configuration file
You edit the Local Authenticator configuration file to change the NMC server address to the Nuance cloud-
hosted NMC server URL. You should have received this address in your welcome information from Nuance.
1. Open the folder where the Local Authenticator is installed. By default, the Local Authenticator is
installed in:
C:\Program Files\Nuance\Local Authenticator
2.
In any text editor, open NMS.LocalAuthenticator.Service.exe.config.
3.
Locate the following line and verify that the value is set to the token that you entered during Local
Authenticator installation:
<add key=”CustomerToken” value=”{Organization token ID added in NMC}” />
4.
Locate the following line and change "nms server address" to the address of the Nuance cloud-
hosted NMC server:
“<add key=”NMSServerAddress” value=”nms server address” />
5. Save your changes.
32