15.6
Table Of Contents
- Client Installation Guide
- Chapter 1: About this guide
- Chapter 2: Preparing to install Dragon
- Chapter 3: Initial Installation of Dragon
- Chapter 4: Installing the Dragon client with settings
- Chapter 5: Configure the Dragon Client for Nuance Management Center
- Appendix A: Modifying nsdefaults.ini
- Appendix B: Options for MSI installations
- Appendix C: Using Dragon over a remote desktop connection
- Appendix D: Working with edit controls
Dragon Client Installation Guide
Configuring the Dragon clients
To enable audio redirection through a remote desktop connection and to allow users to connect and use
Dragon through a Remote Desktop Connection, you must install and configure the Dragon Client for
Remote Desktop on each client computer that needs to connect to Dragon on the server.
1. In Windows Explorer, navigate to the Dragon installer DVD.
2.
Open the DragonClientForRemoteDesktop folder.
3.
Double-click to run setup.exe or dragon-clientinstaller.msi.
4. Follow the prompts to complete the installation.
Configure the microphone
1. On the client computer, plug in the microphone that you're using to dictate with Dragon.
2. Go to Start>Dragon Client for Remote Desktop and open the Audio Setup Wizard.
3. Follow the prompts to ensure that microphone sound levels and signal quality are acceptable.
Configure the Remote Desktop Connection
Note: Depending on which version of Windows you are running, your RDC software interface
may not completely match the screens described in the steps in this section.
1. In the Start menu, search for and open Remote Desktop Connection.
2. In the Remote Desktop Connection window, click Options.
3. Select the Local Resources tab, and then click Settings.
A pop-up dialog window appears.
4. Under Remote audio playback, select Play on this computer.
5. Under Remote audio recording, select Record from this computer.
These options enable audio support when the user runs Dragon over a remote connection.
6. Click OK to close the pop-up window.
7. Recommended for PowerMic users only:
l On the Local Resources tab, set the Apply Windows key combinations field to
Only when using the full screen. Using full-screen mode lets you use the PowerMic
Button Control application correctly.
Note: Key combinations may not work as expected when using full-screen
mode.
l On the Display tab, set the Display configuration to Full Screen.
8. In the Start menu, search for and open the Control Panel on your computer.
9. Open the Sound window. If you do not see Sound in the main Control Panel screen, click
Hardware and Sound and look for Sound within this category.
10. Click the Recording tab and verify that Remote Audio device appears.
89