15.0
Table Of Contents
- Chapter 1: About this guide
- Chapter 2: Preparing to install Dragon
- Chapter 3: Initial Installation of Dragon
- Chapter 4: Installing the Dragon client with settings
- Chapter 5: Configure the Dragon Client for NMC
- Appendix A: Modifying nsdefaults.ini
- Appendix B: Options for MSI installations
- Appendix C: Using Dragon over a remote desktop connection
Chapter 3: Initial Installation of Dragon
l Auto-Formatting—Select the Auto-Formatting options.
NMC users—Administrators can also control these settings in the NMC
console.
l Advanced—Select default settings on the following tabs:
l Roaming (Stand-alone mode only)—Optionally enable and configure the
Roaming feature.
Note: Some Roaming settings are saved in roamingdef.ini. To
include Roaming user settings in future installations, you must pass
this file to the ROAMINGUSERINI option. For more information, see
“MSI properties for Dragon installations” on page 68.
l Miscellaneous (Stand-alone mode only)—Set other administrative options.
l Scheduled Tasks—Enable and schedule Accuracy Tuning (Stand-Alone
mode only) and Data Collection tasks.
l NMS Settings—To configure the client to connect to the NMC server,
select Enable NMS and enter the server address.
Note: You cannot use the NMC console to enable Nuance
Management Center/NMS mode on client computers.
7. Click Install to begin the installation process.
The installation progress bar appears. The process may take several minutes.
8. When the installation is complete, click Finish to exit the InstallShield Wizard.
Dragon saves the configuration you created during setup in nsdefaults.ini. If you set up your
installation for Roaming user profiles, there is also a file called roamingdef.ini. These files are
located in:
C:\ProgramData\Nuance\NaturallySpeaking15
The .ini file(s) contains custom settings that you can apply to each of the Dragon installations you
deploy. Retrieve nsdefaults.ini (and roamingdef.ini, if applicable) and copy to a directory you
can access from the other client computers.
Note: To add or change settings in the .ini files after you complete your initial installation, see
“Natspeak.exe Command Line options” on page 25. Otherwise, see “Overview—Installing the
Dragon client with initial settings” on page 30.
Natspeak.exe Command Line options
To install the Dragon client on other computers with default settings, you must configure your initial
installation using the natspeak.exe command line options. Dragon saves this configuration in the
nsdefaults.ini file in:
C:\ProgramData\Nuance\NaturallySpeaking15
To create or modify nsdefaults.ini, perform the following steps on the workstation where you
created the initial installation of Dragon:
25