Installation Guide

NU‐SETHandsFreeFootPullDoorOpener



TheNU‐SETfootoperateddooropenermountsonanylatch‐lesswoodormetaldoorandgivestheuser

theoptionofpullingthedooropenwiththeirfootinsteadofthedoorhandle.



Installation:

1. MarktheholeswithapencilwhileholdingtheNU‐SETfootpull

againstthedooratalevel

mountingposition.

2. Thebarrelboltisfortheupperhole,andthescrewsareforthelowerholes.Usea⁵⁄₁₆”bitto

drilltheupperholecompletelythroughthedoor.Besuretokeepthedrillperpendiculartothe

doorwhiledrilling.



3. HoldtheNU‐SETfootpullagainstthedoorandinstallthebarrelboltintheupperhole,butdon’t

tightenitcompletely.CheckthattheNU‐SETfootpullislevel.

4. Installthetwolowerscrews.Tightentheupperbolt,thendoublecheckthelowerscrews.To

avoidstrippingthescrewhead,usealargescrewdriverorbit.

5. Openthedoorfullyandcheckforanyinterference issues withthewallorfloormounteddoor

stop.

PAGE 1
NU‐SET Hands Free Foot Pull Door Opener The NU‐SET foot operated door opener mounts on any latch‐less wood or metal door and gives the user the option of pulling the door open with their foot instead of the door handle. Installation: 1. Mark the holes with a pencil while holding the NU‐SET foot pull against the door at a level mounting position. 2. The barrel bolt is for the upper hole, and the screws are for the lower holes. Use a ⁵⁄₁₆” bit to drill the upper hole completely through the door.