Owner Manual

635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax [phone]
www.shop.bluworldusa.com · www.nu-flame.com
Loosen the wind screen clamp thumb screws so you
can easily slide in the glass wind screen panels.
Make certain the glass wind screen panels are well
seated in the clamps and tighten the thumb screws.
Place the heat buffer plate over the glass cutout for
the burner.
Place the burner over the buffer plate and drop into
the glass cutout so it rests flush with the glass base.
Use only a recommended Ventless Fireplace Fuel like “Nu-Flame Bio-Ethanol Fuel”. Make certain the
sliding dampener on the burner slides easily back and forth and is completely open prior to filling. Make
certain the burner is clean and free of dirt or packing debris. Pour fuel into the burner using a funnel. The
burner should be no more than 2/3 full. DO NOT OVERFILL. Wipe up any spilled fuel. Use a long match or
extended lighter to ignite the fuel.
Use the included dampener tool to open and close the dampener, adjusting the height of the flame or to
extinguish the fire completely.
CAUTION: The flame starts out slowly. Please allow 15 minutes to reach the optimum temperature and
flame height. DO NOT ASSUME THE FUEL DID NOT IGNITE. Follow the refilling instructions in this manual.