Owner Manual

635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax [phone]
www.shop.bluworldusa.com · www.nu-flame.com
SETUP INSTRUCTIONS FOR FIERO
Read and Understand the entire Nu-Flame Manual prior to use.
Make certain to inspect the package thoroughly. Carefully remove and unwrap your Nu-Flame fireplace.
Your fireplace will have the following components:
1. Stainless Steel Legs (4 each)
2. Stainless Steel Wind Screen Clamps (with thumbscrews 4 each)
3. Stainless Steel Burner
4. Stainless Steel Rectangular Heat Buffer Plate
5. Glass Wind Screens (2 each)
6. Glass Base
7. Dampener tool
You may wish to purchase a funnel for pouring fuel into the burner
The glass base has a rectangular opening in the
center for the heat buffer plate to sit on and the
burner to drop into. There are 4 holes to attach
the stainless steel legs and stainless steel wind
screen clamps.
Attach the “legs” to the base by lining up the hole
on top of each leg with each hole on the glass
base.
Place a wind screen clamp over each leg (place so
thumb screw faces out on each side). Place a
screw through the center of each wind screen
clamp so it drops straight through the aligned
holes and into the leg. Tighten the screws. DO NOT
over tighten screws as you may break the glass.