Instructions / Assembly

635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax [phone]
http://shop.bluworldusa.com · www.nu-flame.com
Lift the fireplace into position and make certain
the tabs are locked into the mounting holes and
the unit is seated securely on the wall. The tabs
on the vertical bracket will sit under the backer.
Screw in the two smallest screws to secure the
unit to the wall. These screws have one small
washer each. Align the vertical mounting tabs
at the bottom of the fireplace with the screw
holes, thread and tighten the screws to secure.
Slide the glass wind screen into the cutout.
Use only a recommended Ventless Fireplace Fuel like “Nu-Flame Bio-Ethanol Fuel”. Make certain the
sliding dampener on the burner slides easily back and forth and is completely open prior to filling. Make
certain the burner is clean and free of dirt or packing debris. Pour fuel into the burner using a funnel. The
burner should be no more than 2/3 full. DO NOT OVERFILL. Wipe up any spilled fuel. Use a long match or
extended lighter to ignite the fuel.
Use the included dampener tool to open and close the dampener, adjust the height of the flame or to
extinguish the fire completely.
CAUTION: The flame starts out slowly. Please allow 15 minutes to reach the optimum
temperature and flame height. DO NOT ASSUME THE FUEL DID NOT IGNITE. Follow the refilling
instructions in this manual.