Owner Manual

635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax [phone]
http://shop.bluworldusa.com · www.nu-flame.com
Unscrew and remove the thumb screws on the
standoffs from the stainless steel base on each
side.
Align each glass wind screen/leg panel with the
holes on the base; the holes are closer to the edge
of the glass at the bottom of the fireplace (refer to
product photo on page 1).
Place and thread each thumb
screw (with vinyl washer)
through the glass into the
standoff, and then finger
tighten securely, DO NOT OVER
TIGHTEN as you may break the
glass.
Place the stainless steel burner into the black burner holder/base. Make certain it is well seated and free
of debris inside. Place your fireplace on a stable, flat surface for use. Make sure to tighten the thumb
screws periodically as they may become loose over time or with frequent movement.
Use only a recommended Ventless Fireplace Fuel like “Nu-Flame Bio-Ethanol Fuel”. Make certain the
burner is clean and free of dirt or packing debris. Pour fuel into the burner using a funnel. The burner
should be no more than 2/3 full. DO NOT OVERFILL. Wipe up any spilled fuel. Use a long match or
extended lighter to ignite the fuel.
Use the provided snuffer tool to extinguish the flame.
CAUTION: The flame starts out slowly. Please allow 15 minutes to reach the optimum temperature and
flame height. DO NOT ASSUME THE FUEL DID NOT IGNITE. Follow the refilling instructions in this manual.