Tus neeg siv phau ntawv

8 9
HOW TO USE THE HUMIDIFIER (CONTINUED)
SPEED CONTROL
4. The fan speed of the unit can be adjusted when the unit is in operation.
The default speed, when turned ON, is Speed I (Low).
a. 1st Press: Speed II (Medium)
b. 2nd Press: Speed III (High)
c. 3rd Press: Speed Turbo
d. 4th Press: Return to Speed I (Low)
LOW WATER/EMPTY STATUS
When the unit runs out of water, the power indicator light will light up solid
RED, and the unit will run at speed I for a continuous 10 hours. During the
10 hours, you can choose any speed to dry the lter as desired.
• The time needed for drying the lter at Turbo/III/II/I speed is 3/5/7/10
hours.
• Once the continuous operation period ends, the humidier will shut off
automatically.
• If you choose another speed during the continuous operation, the unit
will continue to run for the hours needed to dry the lter at the speed
chosen.
• For example, if you change the speed to Turbo after the unit has
been running for one hour at speed I, the unit will run 3 more
hours before it shuts off.
• At the end of the continuous operation period, there will still be a residual
amount of water in the tank.
• Remove the lter and allow to dry.
• Wipe down the tank with a soft cloth to remove any residual
water.
NOTE:
• If the unit is accidentally turned off during the continuous operation
period, the unit will go back to the previous settings when turned on
again.
• If you press the power button after the unit shuts off automatically, the
RED indicator will light up solid for 5 seconds and the unit will shut off
again until the water is relled.
INSTALLING AND REMOVING THE FILTER
NOTE:
The filter will last approximately 6 months, depending on local air
quality and water hardness.
The “FILTER RESET” light will turn on when it’s time to replace the lter.
1. Lift and remove the top housing by holding the sides of the housing. Do
not lift from the control panel.
2. Remove the lter from the tank and insert the new lter into the unit. Make
sure the plastic portion of the lter is installed upwards and the open end
is facing the bottom of the tank and is ush with the base.
3. Add water to the MAX ll line of the tank.
4. Reattach the top housing of the unit and securely latch into place.
5. Press and hold the Power button for 3-5 seconds to reset the Filter Reset
indicator.
CLEANING & MAINTENANCE
Turn the unit off and disconnect the power plug before cleaning.
NOTE:
Be sure you are near a sink or other water-resistant area before
cleaning.
1. Daily maintenance
a. Fill the tank with clean water and clean it with warm water and a
soft cloth once every 1 to 2 days.
2. Cleaning the tank
a. Lift and remove the top housing.
b. Remove the lter and the oat.
c. Rinse the tank using warm water and a soft cloth.
d. Install the oat and lter and make sure they are installed securely
and correctly
3. Cleaning the housing
a. Wipe with a soft damp cloth.
b. Use a solution of 50:50 vinegar and water or a 3:1 solution of vinegar
essence and water. Do not use abrasive or corrosive cleaners.
4. Cleaning the evaporation mat
a. Remove the lter from the tank.
b. It may be rinsed and soaked in clean water. Low-pressure ushing
is recommended. The cleaning time should not exceed 8 minutes.
c. Water temperature should not exceed 60 degrees. Slight
discoloration may occur when cleaned with water at 60 degrees.
98