User's Manual

Playmaker Signal to Noise Test

Press the <Start> key and then press the Z key after the first beep ends. As the display lights up,

immediately type in the password YFIN or on the playmaker. Press <Enter>. The Playmaker display

will then show:

1)WS 2)ZPwd 3)Cha

4)Rst 5)Tst 6)HwT

7)FTt 8)NPwd 9)Sram Q)Exit

Press 7 and the display will change to:

1)Ch1 2)Ch2 3)Ch3

4)Ch4 5)N/S Ratio

Press 5 and the display will change to:

Welcome

Adc: XXX (Battery Level)

XXX Playmaker Number)

N/S: XXX:XXX YYY (Noise:Signal Channel) <Cancel> to end test

If, by pressing the Z key, the “Password Pls” message does not appear, then the version is probably

one of the older ones. In which case, the N key will be used in place of the Z. In this case, the screen

will be very similar:

1)WS 2)Seq 3)Pwd

4)Cha 5)Rst 6)Tst

7)HwT 8)FTt 9)Sram Q)Exit

From this point, the screens/options are the same.