Tus neeg siv phau ntawv

25
3) Wireless system installation instruction.

Pair the monitor with the camera before installing the wireless system on vehicle:
(1) Before pairing, power off the unpaired camera and switch the monitor channel to the one to
be paired; enter MENU interface, select PAIRING and then press OK; then the monitor enters
the PAIRING countdown of 20 seconds, during which the camera to be paired shall be
connected to the power supply; after 5 seconds, the camera will be paired with the monitor
and the images of the paired camera will be displayed on the monitor if the pairing succeeds.
Otherwise, repeat the above code pairing operation steps.
(2) After one channel of the monitor is paired successfully, switch to the next channel to be
paired; power off the previous paired camera and repeat operation steps above.
(3) After pairing all channels, connect all paired cameras with power supply; press SEL button on
the monitor to switch channels; check images of each channel; and then install the wireless
system on vehicle after confirming that there is image on each channel.
 Solutions for Poor Monitor Signal
(1) Please confirm the height of the camera from the ground is more than 1 meter, the antennas
of the display and camera are perpendicular to the ground, and the antennas are tightened.
(2) If there is metal shielding between the monitor and the camera, an extended antenna should
be used to bypass the metal shielding to ensure smooth transmission of antenna signal in
space.
(3) When using the flat extension antenna, the patch antenna of the monitor and camera shall be
installed on the same side of the vehicle, which is conducive to the transmission of antenna
signal.