Manual

159
System Settings
7
Phantom Power
You can select if the phantom power should be activated or
disabled when the XL2 is powered up.
Off T
he phantom power is switched off when
the XL2 is powered up. Useful, for ex-
ample, when it is common to measure
lines.
Remember The XL2 remembers the setting prior to
the last shutdown. (= default setting)
8
Speaker
Enables/disables the rear speaker. For example, it is recom-
mended that the rear speaker be disabled for all acoustic
measurements. This prevents measuring the audio feed-
back sound loop generated through the rear speaker.
9
USB Mode
The following setting defines how the PC recognizes the
connected XL2:
Ask on
connect
Select
either the Mass storage or COM port
mode after connecting the XL2 to the PC.
Mass
storage
The PC recognizes the XL2 as a mass storage
device automatically, allowing you to down-
load XL2 measurement reports.
COM
port
The PC recognizes the XL2 as a COM port au-
tomatically for application of the XL2 Projector
and the Remote Measurement Option.
10
Decimal Separator
Set the decimal separator to match the generated mea-
surement reports to the PC settings. This simplifies data
post-processing on the PC.
Navigate to the • Dec. Separator function
8
with the ro-
tary wheel
.
Toggle between “• . ” and “ , ” with enter
to set this
parameter.
 The decimal separator is set.