Manual

NOTE Only the last recorded sweep curves will be stored
independent on the selected user setup.
d.d.
d.d.
d.
Indicator for Operation / Low BatteryIndicator for Operation / Low Battery
Indicator for Operation / Low BatteryIndicator for Operation / Low Battery
Indicator for Operation / Low Battery
In the right hand field of the ML1 menu bar, a moving sine symbol
indicates the unit is running properly.
Alternatively, if the inserted
batteries are almost exhausted,
this field will show a battery-low
indicator (Fig 8)
NOTE As soon as the
batteries are
discharged, they
must be removed
from the ML1, in
order to avoid
damage due to
leakage.
Fig 7 Multiple User Startup Screen
c.c.
c.c.
c.
SetupSetup
SetupSetup
Setup
The setup screen allows to customize basic settings of the Minilyzer ML1
by the following procedure:
• Move the cursor to the corresponding field and press enter
• Select the required status by using the arrow keys
• Press the enter key to confirm
AUTO POWER OFF defines the time after the ML1 is switched OFF
automatically after the last key-press. The available settings are 3 MIN,
10 MIN, 30 MIN, 60 MIN and DISABLE. In case DISABLE is selected,
the user has to turn the unit off manually or it will run until the batteries
are discharged.
AUTO LIGHT OFF defines how long the backlight stays on after being
activated. Possible selections are 3 SEC, 10 SEC., 60 SEC. and DISABLE.
In the latter case, the backlight will stay on, until the unit is switched
off. The longer the backlight is turned on, the shorter is the lifetime of
the batteries.
LCD CONTRAST adjusts the contrast of the display. Alternatively, press
the ESC and up/down arrow key simultaneously in any measurement
panel.
MULTIPLE SETUP allows four users to store their individual settings. To
enable the multiple setup mode, set the corresponding entry to ENABLE
and confirm. At the next the Minilyzer is switched on, the user will
have to select the individual setup-ID (1, 2, 3 or 4) in the startup
screen (Fig 7). All parameter settings in all measurement modes are
now stored under this ID at switch off and are recalled if this ID is
selected at the next start up.
Fig 6 Setup Screen
Basic Operation
2-072-06
Basic Operation
Fig 8 Low Battery Indicator