Manual

ManualsBrandsNTI Audio ManualsAudiotoolsAnalogue Audio Analyzer

3.113.11

3.11

ScopeScope

Scope

To activate the SCOPE mode, select the entry SCOPE in the measurement

functions menu.

The SCOPE screen visualizes the waveform of the input signal. It

automatically triggers to the fundamental frequency and selects the

scaling of the X-axis (time) and Y-axis (level) accordingly.

Furthermore, the input signals fundamental or most dominant frequency

is displayed near the lower right corner of the scope screen.

NOTE The scaling of the SCOPE display cannot be changed

manually.

Fig 25 Scope Screen

Measurement Functions

3-20

4.4.

TROUBLESHOOTINGTROUBLESHOOTING

TROUBLESHOOTING

4.14.1

4.1

System Break DownSystem Break Down

System Break Down

• Switch the device off.

• Reset the ML1 to the default status by pressing the ESC button

and switching the Minilyzer on simultaneously.

• Release the ESC button.

• The below screenshot, Fig 26, shall appear on the display, stating

on the bottom line LOADING DEFAULT SETUP.

• Verify the correct operation.

In case you find system breakdowns happening several times or your

device is malfunctioning please contact the local NTI representative in

your country. For contact-details please see the NTI web page: www.nt-

instruments.com

4.24.2

4.2

Low Level MeasurementsLow Level Measurements

Low Level Measurements

4-01

Fig 26 Start Up Screen Loading Default Setup

The Minilyzer does automatically

recognize the actual input (XLR or

RCA) in use. To measure low level

audio signals (< 70 dBu) the

balanced input shall be used only.

Unbalanced signals need to be

connected to the XLR-input via an

XLR/RCA-adapter.

Fig 27 XLR/RCA Adapter

Hot