User Manual
Reversible vibratory plate Operation Manual
page 7 issued 03/2016
1.3. Hygienical Principles
Oil derivates (fuel, lubricants) are harmful agents. Anyone who gets into contact with such agents is
obliged to protect himself and follow general principles of health protection as well as to follow
instructions valid for each specific agent.
Pay special care to:
skin protection against direct contact with oil derivates;
wash hands properly after finishing the work and apply suitable hand cream.
Store the fuels, lubricants, cleansing and conservation agents, as well as other dangerous agents in
original containers, properly sealed. Never allow storing in unmarked bottles or containers or even in
beverage bottles. Store such agents in safe place, out of reach of children.
In case that the agent gets into touch with skin or eyes, or when it is eaten or inhaled, apply the first aid
and get immediately medical aid.
1.4. Environmental Principles
Fuel, lubricants and other operational fluids are harmful to environment. This category also includes part
of the machine that get into contact with operational fluids, such as filter and hydraulic hoses.
After use these belong to dangerous waste.
Pay high attention to avoid leakage of the fluids and their escape into soil or water (including the
sewage).
Store the fluids in such manner, that the fluids gets caught in case of accidental leakage.
If these agents still escape, arrange their safe collection and liquidation (spread with an absorbent and
commit to a specialized company).
Used operational fluids are to be disposed off in accordance with the respective regulations.
1.5. Liquidation of the Machine after Termination of its Service Life
After the machine exceeds its service life, the contractor is obliged to arrange its proper liquidation in
accordance with the respective lawful regulations and with regards to environmental protection.
Oil fills have to be removed from the engine and from the vibration mechanism, and the used filters have
to be dismantled.
In accordance with the law of waste disposal, the owner of the machine to be disposed off is obliged to:
commit the metal parts only to persons authorized to liquidate, collect and buy-out this type of waste;
used engine oil and used hydraulic oil can be committed only to persons authorized to handle waste
oils.
Company NTC does not bear any responsibility for user’s health or environmental damages caused by
failure to keep the above mentioned hygienical and environmental principles.
1.6. Safety Instructions for Work with Compaction Machines
Vibratory plates, vibratory tampers and vibratory rollers belong among compaction machines. When
operating such machines, the following safety instructions have to be observed:
1. Prior to starting the work, find out bearing capacity of the terrain, locations of underground spaces
and paths of underground civil lines, in order to avoid sinking of the machine or damage to the
underground object.
2. When working close to a building, always consider whether the building cannot be damaged from
transition of vibrations.
3. When working in trenches, make sure that the sides cannot slide down and bury the operator.
4. When working on edge of slopes, always work only in sufficient distance from the edge, to prevent
soil slide and/or rolling over or fall of the machine.
5. Never work with the machine in such inclination, where is a risk of machine rolling over or where
lost of adhesion and uncontrolled sliding of machine may occur.










