User Manual
Reversible vibratory plate Operation Manual
page 13 issued 03/2016
At correct oil level, oil is reaching just to the edge of the filler and slightly is pouring out.
If the oil level is lower then the edge of the filler, top up oil.
If oil leakage is found, stop the machine immediately and call service, or contact the manufacturer.
Checking the oil level in HATZ 1B30 and 1B50 engines should be carried out as follows:
Place the machine into a horizontal position.
Clean the plug (1) and unscrew it from the filler (2) on the engine.
Clean the filler cap with the dipstick with a clean cloth.
Screw the dipstick into the filler and unscrew it again. The oil level should be between the “MIN” and
“MAX” marks at the disptick.
Should the oil level be below the “MIN” mark, add recommended oil into the engine, up to the upper
mark “MAX”.In case that any oil leakage is found, stop the machine immediately and call service or
contact the manufacturer.
1
2
min.
max.










