User's Manual
Table Of Contents
- 1 Introduction
- 2 Available Models
- 3 Scope of Supply
- 4 Technical Specifications
- 5 FCC and IC Compliance Notes
- 6 Ports
- 7 Supported Card Standards
- 8 LED / Beep Status
- 9 Mounting Options
- 10 Copy Control Cables
- 11 Installation
- 12 Configuration
- 13 Job Release via uniFLOW Release Station
- 14 Index
uniFLOW Release Station
14
The general configuration set here is only used, if no settings are made under Specific
Settings (on page 15) for the corresponding uniFLOW Release Station.
List view
This section lists all configured EAI devices in uniFLOW. The uniFLOW Release Station is
listed here as well. The uniFLOW Release Station can be configured by clicking the
button. This will open a new window with device specific settings. Please refer to the
chapter Specific Settings (on page 15) for a detailed explanation of these options.
Network Configuration
Here you can configure the IP address of the uniFLOW Release Station.
IPs:
Currently configured EAI devices and their IP addresses.
Device:
IP address of the uniFLOW Release Station.
Server:
http://<uniFLOW_Release_Station>:8000/mom/eai.htm
Update interval in sec.:
The interval in which EAI devices are being detected by uniFLOW or an RPS.