User's Manual
Table Of Contents
- 1 Introduction
- 2 Available Models
- 3 Scope of Supply
- 4 Technical Specifications
- 5 FCC and IC Compliance Notes
- 6 Ports
- 7 Supported Card Standards
- 8 LED / Beep Status
- 9 Mounting Options
- 10 Copy Control Cables
- 11 Installation
- 12 Configuration
- 13 Job Release via uniFLOW Release Station
- 14 Index
uniFLOW Release Station
16
Card Registration Method:
If you have unknown cards in the system and you are using a Card Reader for the
authentication, you can select a card registration method here. This can either be
via UserName/Password or via TIC (Temporary Identification Code).
12.2 uniFLOW Release Station Website
The uniFLOW Release Station website contains general information and configuration
options about the device like its firmware version, its serial number and its current IP
address.
The website can be accessed under:
http://<uniFLOW_Release_Station>:8002/config.htm
The following chapters explain the different web pages.
12.2.1 Release Station
The Release Station site gives information about the following:
Serial Number:
This is the serial number of the uniFLOW Release Station itself. It is used to select
a uniFLOW Release Station during the printer wizard. You will also find this
number on a sticker on the back of each uniFLOW Release Station.
The serial number of the uniFLOW Release Station is derived from its MAC address
(without colons and leading zeros).