User's Manual

7
microMIND - Installation Guide
Important Note:
Changes and/or modifications of the microMIND not approved by NT-ware
Systemprogrammierung GmbH will make void the user’s authority to operate
the microMIND.
2.4
FCC and IC Compliance Note
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
2.5
Installation
Required components:
microMIND
Power supply for the microMIND if no PoE support
Printer
Ethernet patch cable (delivered with the microMIND)
MiCard (V2)
USB cable (delivered with the MiCard (V2)
Installation
1.
Switch off the desired printer.