User's Manual

MiCard V3 Installation Manual (Full Install Guide)
15
3.1.2 Configuration - Multi
On this page options for the contactless card reader Multi can be configured.
The contactless card reader Multi offers four different card technologies, ISO 14443A,
ISO 15693, Legic Prime and Inside contactless. However, the MiCard V3 only allows
one ID or card technology to be read at the same time. This makes sense, as only one
ID should be transmitted to the uniFLOW Server or RPS in order to identify the user.
In general a card carries only one technology. Therefore, and to have the highest
compatibility, all possible card technologies are enabled by default.
However, some cards in the field contain more than one technology. In such cases
disable all the technologies you do not want to use for reading out the ID. Otherwise,
the MiCard V3 reader cannot read out the correct ID.
In addition to that, you can enter which Sector Number or Sector Type contains the
user ID. In case you leave all fields empty on the Multi config page, the <UID> of the
card will be read out and transmitted.
Enable ISO 14443A
-factory default- (Yes)
No
Yes
Enable ISO 15693
-factory default- (Yes)
No
Yes
Enable Legic Prime
-factory default- (Yes)
No
Yes
Enable Inside contactless
-factory default- (Yes)
No
Yes
Sector Number
Enter the sector number which contains the user ID.
Sector Type
Enter the sector type which contains the user ID.