User's Manual

MiCard V3 Installation Manual (Full Install Guide)
14
3.1 Global MiCard V3 Configuration
With MiCard V3, it is possible to configure the MiCard contactless card reader right
from the uniFLOW server. To do so, go to Connections / MEAP & miniMIND (uniFLOW
V5.x: Connections/Agents/Terminals/MiCard V3, then open the Global MiCard V3
Config. tab Multi.
You can configure the MiCard V3 for a number of different contactless card types:
 Multi for Legic cards
3.1.1 Configuration - General
Here, you have the possibility to change the general options.
Beeper
This field allows you to set basic options for the card readers' beeper
-factory default- - restores the manufacturers' presets.
off - The beeper will not emit any audible signals when presenting a card. All other
signals are still emitted.
on - The beeper never suppresses any audible signal.