User's Manual

MiCard V3 Installation Manual (Full Install Guide)
13
Once the upload is complete, the MiCard (V3) is automatically rebooted with the new
Firmware. A device restart is not necessary.
If the update fails, the MiCard will start in a "Bootloader" mode that allows updating
the Firmware again, but has no card reading functionality. Note, with a failed Firmware
update, it can take a considerable amount of time before the reader is once again
visible in uniFLOW.
2.1 Upgrading from SSP to uniFLOM OM V4.1 or
uniFLOW V5.0
If you are upgrading from SSP to uniFLOW V4.1 or V5.0 and are using the MiCard,
observe the following:
If you use some new Canon printing devices with MEAP, you have to enable the Use
extended Card Format function for the new devices.
You'll find this option on the MEAP Configuration website. Therefore click on in
the ID-Device column on the MEAP & miniMIND Status page. In the pop-up window
click on config - behind Connected ID Module.
The reason for this is that devices configured with SSP use the extended Card Format.
You need to enable this setting in order to make the new machines compatible in an -
already set up - environment.
3 MiCard V3 Configuration on the uniFLOW
Server
The MiCard V3 contactless card reader is available as MiCard V3 Multi, supporting
different RFID frequencies and technologies.
The following chapter explains the global and device specific configuration of the
MiCard V3 in uniFLOW. The configuration Multi has been explained in detail, in a
separate sub-chapter.