User's Manual

MiCard V3 Installation Manual (Full Install Guide)
11
Click on the ID-Device column to open a configuration pop-up. This will look like the
screenshot below:
The terms used and the possible settings of the configuration window are as follows:
Connected ID Module
Shows the ID Module connected, e.g. MiCard / miniMIND.
Last Read ID
Shows the last ID read by a card swipe.
Conversion Result
Shows the result of the last read ID when the configured code conversions are applied.
This is the ID sent to the server for authentication.
Code Remove First
Specifies the number of characters to be removed from the start of the ID read before
the code conversion takes place. For instance a value of 3 applied to A881C045 will
result in 1C045.
Code Remove Last
Specifies the number of characters to be removed at the end of the ID read before the
code conversion takes place. For instance a value of 3 applied to A881C045 will result
in A881C.
Code Length
Specifies the code length applied after the code conversion. For instance a value of 6
applied to A881C045 will result in A881C0, whereas a value of 10 applied to
A881C045 will result in 00A881C045.
Code Conversion No. [N]
Specifies the code conversion that has to be applied to the ID read in a series of code
conversions at step [N]. The results of the code conversions at step [N] are displayed