User's Manual

MiCard V3 Installation Manual (Full Install Guide)
9
 On other imageRUNNER ADVANCE models like the C9070PRO for example, or the
C7065, open the toner cartridge cover and unscrew the two card reader cover
screws as shown in the picture. Proceed as described above.
1.7 LED Status
The MiCard V3 reader is equipped with 3 status LEDs: green (left), yellow (middle) and
red (right). The table below shows the status information given by the respective LED.
Status
Green LED
Yellow LED
Red LED
Booting up
flashing
flashing
Not synchronized
flashing
Synchronized (operating)
flashing
Authentication OK
on
flashing
Authentication failed
flashing
on
1.8 Beep Status
The MiCard V3 reader is equipped with a little beeper which emits different beep
tones for different statuses. The table below shows the status information given by the
beeper.
Status of the Beeper
Beep Signal
The MiCard V3 is booting up.
2 x fast
The MiCard V3 is not parameterized which means, there was
no saved config found.
2 x slow
The MiCard V3 is parameterized. A configuration was found
on the device.
1 x short
If parameters are sent to the MiCard V3
2 x slow
A card has been detected.
1 x long