User's Manual

3
2.1 Scope of supply
The MiCard® reader package consists of the MiCard® Reader itself and the
appertaining connection cable.
2.2 Requirements
Rated Voltage: 5 V
USB 1.1 Full Speed
Ambient temperature 0 … +50 °C
Canon iR:
- has to be MEAP enabled
- USB Application Interface board of the respective iR
- uniFLOW OM Login Manager/MomClient (Secure/Public Printing Applet) v2.1.0
uniFLOW OM:
- uniFLOW OM/RPS v3.1 required /
uniFLOW OM / RPS v3.1.1. recommended
Important Note:
Changes and/or modifications of the MiCard® not approved by NT-ware
Systemprogrammierung GmbH will void the user’s authority to operate the MiCard®.
FCC Compliance Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.