Technical Specs

DISASSEMBLY

Ÿ Before you disassemble the set, turn off power and pull out the power plug.

Ÿ Use a proper screwdriver. If you user screwdriver that does not fit, you may damage the screws.

Ÿ Disassembly is the opposite process of assembly.

Ÿ Carefully discharge the CRT anode potential by grounding to CRT dag ground harness before

removing Anode Cap.

MAIN BOARD and CRT BOARD

EXPLANATION

1. Disassemble a screw like a picture.

2. Unsolder the GND wire (CRT coating earth wire) from MAIN BOARD ASSY and CRT BOARD ASSY.

This model has two kinds of CRT. Depend on CRT, the GND wire assembly is some different. Be

careful.

3. Disconnect the connector “ S201” , “ S202” , “ S203” , Coating earth connector, and screen lead from the

CRT BOARD ASSY.

4. Disconnect the CRT BOARD ASSY from the CRT.

5. Disconnect the connector “ S301” , “ S601” , “ S703” , “S701” , “S104” and “ P102” from the MAIN BOARD

ASSY.

6. Remove the Anode Cap from the CRT.

NOTE: Carefully discharge the CRT anode by shorting it to ground before removing Anode Cap.