Technical Specs

Input Output

Sync Sync PS CS

Mode State

H V H V

Mute

1 2 1 2 3 4

ON Pulses Pulses Pulse Pulse L H H Depend on fH

Stand By No pulses Pulses L L H L H L L L L

Suspend Pulses No pulses L L H L H L L L L

User

PMS_OFF No pulses No pulses L L H L L L L L L

ON Pulses Pulses Pulses Pulses L H H Depend on fH

Stand By No pulses Pulses L L L H H L L L L

Suspend Pulses No pulses L L L H H L L L L

Factory

PMS_OFF No pulses No pulses L L L H H L L L L

Input Output

Sync Sync Rotation SW

Mode State

H V H V DAC 1 2 3

ON Pulses Pulses Pulse Pulse Adj. data Depend on fH

Stand By No pulses Pulses L L 107/255 H H H

Suspend Pulses No pulses L L 107/255 H H H

User

PMS_OFF No pulses No pulses L L 0/255 H H H

ON Pulses Pulses Pulses Pulses Adj. data Depend on fH

Stand By No pulses Pulses L L Adj. data H H H

Suspend Pulses No pulses L L Adj. data H H H

Factory

PMS_OFF No pulses No pulses L L Adj. data H H H

(b) The U702 is an EEPROM IC which stores the parameters of each mode and the user adjusting result

and also DDC data. It is controlled by IIC bus from MCU.

4. Vertical Deflection

(a) Vertical deflection Saw-tooth waveform is provided by U301, pin 23, and amplified by U401 TDA8172.

(b) A voltage multiplier connected to pin 3 and pin 6, consists of D402, C409 to avoid flyback scanning line

appeared during the vertical flyback period.

(d) U401 pin 5 is output to drive vertical yoke.

5. Horizontal Deflection

(a) U301 is a horizontal signal processing IC. Horizontal Driver signal is output from pin 26 of U301

TDA9111 and through Q333, Q334 to drive Q316 and T301.

(b) T301 is an on/off type driver transformer. It functions to convert primary energy to secondary, and drive

the horizontal output transistor Q315, R369 and C363 are the snubber.

(1) Horizontal linearity and Cs is changed by RL301,RL301 can change Horizontal

Tr(C337),Linear(L302) and Cs(C336).It control by HF/S from U701 pin 30