User manual

4746
NOXON NOVA
Remember to pull out the clear plastic tab from the battery compartment before using the remote.
To remove the battery from the remote, use your thumb to press and pull it out. Replace it with a
CR2025 type 3V battery, taking care to insert it with the positive (+) side up.
Caution: Risk of explosion of battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
4. Getting Started
The items enclosed in the packaging box are as follows:
• NOXON NOVA unit
• Power adaptor
• Audio cable with 3.5mm jack at both ends
• Telescope antenna for DAB+ and FM
• User manual
Connect the power adaptor to the back of NOXON NOVA and plug it into power socket.
Get the network environment ready
• For wired Ethernet
Use an Ethernet cable (RJ45 jack) to connect the LAN ports on NOXON NOVA and your
network device. Check if the light indicators on the
network device are in appropriate status.
• For wireless WiFi
Make sure you have setup the wireless network
and you have the WEP, WPA or WPA2
security password to activate the connection.
You may also use the WPS (WiFi Protected
Setup) function for easy pairing between
the network device and NOXON NOVA. Check
if the light indicators on the network device
are in appropriate status.
Switch it on from NOXON NOVA
At the rst time operation, system asks if you want to start the Setup Wizard. Select YES to conti-
nue the setup. Details of the Setup Wizard can be referred to Section 5.2.1 below. After choosing
NO, the next screen asks if you would like to run the wizard next time NOXON NOVA is started.