Operation Manual

NOXON iRadio Cube
ENGLISH 33
Setting up myNOXON
myNOXON can be used immediately without registering, though with limited function. To use the full
range of function or configure the desired content, you have to activate your NOXON at the TerraTec site.
This is fast and free of charge, and takes only a few steps:
1) Go to the www.my-noxon.net website. Select the "Register now" menu item.
2) After completing the registration, go to device management menu by clicking "myNOXON".
3) There, select "My devices". You can register your NOXON here.
To do so, open the "myNOXON" menu on your NOXON. If the device is not yet registered, the "Register
NOXON" menu item appears, which you should select.
4) A registration code appears on the display. Enter it on the website along with the MAC address of your
device. The MAC address of your NOXON (a 12-digit number combination separated by dashes) is
listed on the sticker on the rear side of the device or in the "Device status" menu. You do not need to
enter the dashes, just the numbers
5) Your device is now registered for use on myNOXON.
My Services of myNOXON
Subject to change without notice. The selection of services is
growing constantly.
Under myNOXON -> My Services, you
can activate or deactivate the desired
services as necessary.
Accordingly, only the desired services
are shown on the NOXON display
under myNOXON.
For more information on the services,
visit http://www.my-noxon.net