Operation Manual

NOXON iRadio Cube
ENGLISH 23
7 - The setup menu of your NOXON
Press the button of the remote control to open the setup menu of the device. There you will find the
following entries:
Setup menu
Device status Important indicator for problems: query of current parameters such as IP address,
MAC No., firmware and bootloader version, etc.
Internet radio
Submenu for configuring the station directory—see the chapter on "The radio sta-
tion directory"), page 28
Configuration wizard Start the network configuration wizard here.
Select language Select a language for the menus here.
Software Update Your device can update itself automatically with the latest software version. You can
configure the corresponding settings in this menu.
Other settings To the Advanced Settings submenu (see below.).
Config. Date/Time All settings that relate to your NOXON's internal clock.
Equaliser Configurations for the equaliser to adjust the sound (see below)
Other settings
Select profile Switch between the various location profiles, for example if you want to register your
NOXON on different networks.
Profile management With the profile management activated, another profile is selected automatically any
time the connection is lost. This also lets you switch locations easily without setting
up the same profile each time. Enable or disable profile management here. Select the
profile you intend to use under "Profile Selection".
Key management If more than one network key has been stored, the key management will attempt to
use them to maintain contact to the AP / network access point.
Edit device name Assign a name to the device here.
LCD brightness Controls the brightness of the LCD. The following options are available:
Low – The "evening setting": The display is set to continuous low brightness.
High – The display is set to continuous full brightness.
Automatic – The software determines the brightness based on how the NOXON is
being used. In the normal case, the display is set to high brightness, but is dimmed if
there is no activity for a certain amount of time or if the shutoff timer is in use.
FM sensitivity Sets the sensitivity of the scan (high = many stations, low = only stations with high
reception quality)